How to Bend a Gabion Back into Place

Below you will find a step-by-step guide on how to bend a gabion back into place.

• Experience Required: Low
• Tools Required: Protective gloves, Rubber hammer
• Materials Required: Gabion baskets

Introduction

• Gabions can sometimes get bent out of shape if they take a hard hit during transport. However, you can easily knock them back into shape using a rubber hammer.
• This won’t compromise the strength or integrity of the basket, as they are designed to be flexible.

 

Step 1) Unfold the Gabion

• Start by unfolding the gabion on a stable, solid surface to ensure proper support while working.

 

Step 2) Knocking Wire Back into Shape

• Place the gabion on a solid surface and carefully tap it back into shape using a rubber hammer.
• Ensure that you apply gentle and consistent taps to avoid causing any damage to the wire.

 

Step 3) Continue the Process

• Continue this process on each side of the gabion, gently knocking it back into shape wherever you see a bend.

 

Step 4) Final Check & Adjustments

• Inspect the gabion for remaining bends or irregularities, ensuring the wire is intact.
• Make any final adjustments to ensure it’s properly aligned and secure.

Further Tips on How to Bend a Gabion Back into Place

• Select an appropriate wire thickness for your basket based on your project, with a minimum of 4mm recommended.
• It’s important to avoid low-quality or thin wire baskets, as they may not provide the necessary durability.
• To prevent damaging the gabion wire, always use a rubber hammer, as metal hammers can cause dents, weaken the wire, or even break it.
• When using a rubber mallet, apply gentle, consistent taps instead of strong, forceful hits.

FURTHER READING

• How To Assemble Gabion Baskets – Step by step instructions on how to assemble baskets.
• How to Lace Gabion Baskets – Learn how to lace wire cages using different methods.
• How to Fill Gabions – A guide showing you how to fill cages.

Videos